Reloading Tools
-
LEE CARBIDE 3-DIE SET 9X18 MAKAROV
Learn MoreFEATURES
-For 9mm Makarov
-3-die set
-Carbide full length sizing die
-Bullet seating die
-Powder thru expanding die
-Universal shell holder
-Powder dipper
-Instructions/load data$52.33 -
LEE QUICK TRIM DIE BODY 9X18MM MAKAROV
Learn MoreFEATURES
-Quick trim die for 9x18mm Kakarov$15.47MSRP: $16.00
You save: $0.53 (3%)
-
LEE CARBIDE FACTORY CRIMP DIE 9MM MAKAROV (9X18)
Learn MoreFEATURES
-For 9mm Makarov
-Sizes the cartridge while being crimped
-Every round will positively chamber freely
-Applies a roll crimp
-Adjusting screw quickly & easily sets desired amount of crimp$27.56MSRP: $28.98
You save: $1.42 (5%)
-
RCBS CARBIDE TC DIE SET 9MM MAKAROV/9X18MM
Learn MoreFEATURES
- Caliber: 9mm Makarov/9x18mm
- 3-Die Sets for straight-wall rifle & pistol cases
-The Carbide Sizer Die sizes the case & de-primes (the carbide sizer ring eliminates the need to lubricate)
-The Expander Die expands the case to the proper diameter to accept the bullet, & it imparts case mouth
flare/bell for bullet feeding
-The Seater Die seats the bullet & taper crimps -
LEE FULL LENGTH 3-DIE SET .220 SWIFT
Learn MoreFEATURES
-Pacesetter 3 die set for .220 Swift
-Full length sizing die
-Bullet seating die
-Factory crimp die
-Universal shell holder
-Powder dipper
-Instructions/load data -
LEE COLLET 2-DIE SET .220 SWIFT
Learn MoreFEATURES
-For .220 Swift
-Collet die set
-Includes a Collet die, Dead length bullet seater die, shell holder, powder dipper, and loading data -
LEE FACTORY CRIMP DIE ONLY .220 SWIFT
Learn MoreFEATURES
-Factory crimp die for .220 Swift
-Crimps bullet in place more firmly than any other tool
-A firm crimp improves accuracy
-Higher start pressure insures a more uniform pressure curve & less velocity variation -
RCBS FL DIE SET .220 SWIFT GP-A
Learn MoreFEATURES
-Caliber: .220 Swift
-This two-die set is intended for reloading bottleneck cases, & consists of a Full-Length Sizer Die
with an Expander-Decapping Unit, & a Seater Die with Bullet Seater Plug.
-The Full-Length Sizer Die brings the case to SAAMI minimum cartridge dimensions
-It sizes the outside of the case, de-primes & expands the neck to accept the bullet
-The die vents to prevent case damage caused by trapped air & for excessive lubricant
-Headspace is held to minimum tolerances to avoid changing the case body length during full length sizing
-Then included Seater Die has a built-in roll crimper to secure the bullet at the same time as it's seated