Reloading Tools

FEATURES:
-Caliber: .223 Remington
-Allows the user to trim cases by hand or with a power attachment (included) to precise pre-set length
-The trimmer comes with a case locking device, cutter, trim-to-length pilot, cutter head & both hand & power
trimming adapters

FEATURES
-.22 to .50 caliber
-Features a specially designed drop tube to avoid any messy powder spills around case mouths
-Non-stick, anti-static surface
-Square lip keeps the funnel from rolling around.
-Spout will accommodate the WSM family of cartridge

FEATURES
-For .40Smith & Wesson Pistol
-3-die set
-Carbide full length sizing die
-Bullet seating die
-Powder thru expanding die
-Universal shell holder
-Powder dipper
-Instructions/load data

FEATURES
-Caliber: 7.62X54 Russian
-This two-die set is intended for reloading bottleneck cases, & consists of a Full-Length Sizer Die
with an Expander-Decapping Unit, & a Seater Die with Bullet Seater Plug.
-The Full-Length Sizer Die brings the case to SAAMI minimum cartridge dimensions
-It sizes the outside of the case, de-primes & expands the neck to accept the bullet
-The die vents to prevent case damage caused by trapped air & for excessive lubricant
-Headspace is held to minimum tolerances to avoid changing the case body length during full length sizing
-Then included Seater Die has a built-in roll crimper to secure the bullet at the same time as it's seated

FEATURES
-Shell Holder #5
-Built from hardened steel
-Designed to properly align the case with the reloading die in single-stage & turret presses
-Sized to fit specific case heads & capture 0.125" of the case head for proper SAAMI head spacing

FEATURES
-.357 Magnum
-Incorporates a collet to apply a rifle type crimp to the case
-Makes these very difficult to crimp cartridges a delight to reload
-Bullets do not need a crimp groove, as the collet is so powerful it will form one

Note: This die is not carbine.

FEATURES
-For .338 Lapua Magnum
-Case Length Gauge
-Precise, easy way to trim to length & square the case mouth
-Used with the Cutter & Lock Stud or Zip Trim

FEATURES
-For 8x57 Mauser
-Case Length Gauge
-Precise, easy way to trim to length & square the case mouth
-Used with the Cutter & Lock Stud or Zip Trim