Reloading Tools

FEATURES
-Extremely efficient design for ease & speed of depriming
-Universal collet system to deprime brass from .20 cal up to .338 Lapua
-Robust die cast aluminum construction for extended use
-Auto-ejecting case holder for easy removal of deprimed cases
-Comes with 3 different collets for different diameter cases
-Features an easily removable spent primer catch tube
-Easily deprime crimped primers
-Works on pistol & rifle brass
-Ergonomic grip

FEATURES
-.44 Magnum
-Incorporates a collet to apply a rifle type crimp to the case
-Makes these very difficult to crimp cartridges a delight to reload
-Bullets do not need a crimp groove, as the collet is so powerful it will form one

Note: This die is not carbine.

FEATURES
-.500 S&W
-Incorporates a collet to apply a rifle type crimp to the case
-Makes these very difficult to crimp cartridges a delight to reload
-Bullets do not need a crimp groove, as the collet is so powerful it will form one

Note: This die is not carbine.

FEATURES
-No spring in this turret design
-Locked into a solid steel ring with big rifle bolt type lugs
-Puts the lugs on the circumference so there can be no tipping
-Linkage is so powerful that the largest magnum cases are sized with ease
-Built-in primer catcher, longer stroke, more hand clearance and a comfortable new foam grip
-Forth hole in the turretallows you to install your Lee Factory Crimp Die or taper crimp die
-Capable of loading cartridges with an overall length of 2.313" or less

FEATURES
-Ultimate 4-die set for 6.5 Creedmoor
-Full length resizing die
-Collet necksizing die
-Easy adjust dead length bullet seating die
-Factory Crimp Die
-Shell holder
-Powder measure
-Load data

FEATURES
-Pacesetter 3 die set for .300 Winchester Short Magnum
-Full length sizing die
-Bullet seating die
-Factory crimp die
-Universal shell holder
-Powder dipper
-Instructions/load data

FEATURES
-Holds approximately 20 pounds of lead
-3 3/4" of clearance under the spout accepts all brands of bullet molds & most sinker molds
-Includes an adjustable mold guide
-High-efficiency design
-Remote sensing thermostat
-Dust-tight housing
-Long life 700-watt tubular heating element
-Micro-adjustable flow control valve adjusts with a screwdriver
-Front mounted low maintenance replaceable valve spout
-Melter will reach between 450°F - 900°F
-Dimensions: 9.5"L x 7"W x 10.5"H

FEATURES
-Large 4" diameter pot allows easy access for the ladle caster
-Melt time is less than 20 minutes with just 700 watts
-20 pound capacity
-Melter is capable of reaching 900°F
-110 Volt only

FEATURES
-Includes cutter & lock stud, chamfer tool & primer pocket cleaner