Reloading Tools

FEATURES
-Undersize mandrel for .243 Winchester & 6mm Remington
-For a tighter fit than a factory collet die

FEATURES
-Holds approximately 10 pounds of lead
-Melt time is less than 20minutes
-Pour spout in front
-Infinite heat control
-Uses only 500 watts of power during heat-up & a lot less to maintain temperature
-Large, stable base
-4" of clearance under the spout is high enough to accept all brands of bullet molds & most sinker molds
-Melter is capable of reaching 900°F

FEATURES
-12 gauge
-1 1/8 oz. charge bar
-Bushings: 29, 30, 32
-Works on six shells at once
-Fully automatic primer feed
-Auto-cycle charging
-Three-stage crimp
-"Power Ring" resizer
-Automatic indexing
-Finished-shell ejection
-Auto-Dex™ automatically moves the shells through each reloading stage by
simply returning the handle to the top of its stroke

FEATURES
-20 gauge
-7/8 oz. charge bar
-Bushings: 20, 22, 24
-Works on six shells at once
-Fully automatic primer feed
-Auto-cycle charging
-Three-stage crimp
-"Power Ring" resizer
-Automatic indexing
-Finished-shell ejection
-Auto-Dex™ automatically moves the shells through each reloading stage by
simply returning the handle to the top of its stroke

FEATURES
-28 gauge
-3/4 oz. charge bar
-Bushings: 14, 16, 21
-Works on six shells at once
-Fully automatic primer feed
-Auto-cycle charging
-Three-stage crimp
-"Power Ring" resizer
-Automatic indexing
-Finished-shell ejection
-Auto-Dex™ automatically moves the shells through each reloading stage by
simply returning the handle to the top of its stroke

FEATURES
-.410 bore
-1/2 oz. charge bar
-Bushings: 10, 11, 12
-Works on six shells at once
-Fully automatic primer feed
-Auto-cycle charging
-Three-stage crimp
-"Power Ring" resizer
-Automatic indexing
-Finished-shell ejection
-Auto-Dex™ automatically moves the shells through each reloading stage by
simply returning the handle to the top of its stroke

FEATURES
-12 gauge
-Includes 24 shot & powder bushings
-Loads 2 3/4" & 3" shells

Note: This press cannot load 2 1/2" or 3 1/2" shot shells

FEATURES
-20 gauge
-Includes 24 shot & powder bushings
-Loads 2 3/4" & 3" shells

Note: This press cannot load 2 1/2" or 3 1/2" shot shells

FEATURES
-16 gauge
-Includes 24 shot & powder bushings
-Loads 2 3/4" & 3" shells

Note: This press cannot load 2 1/2" or 3 1/2" shot shells